ArcticAire 30 BTU DehumidifierADR30A2G This product is no longer available.
You can improve your comfort and health with this quiet and sleek 30 pint (14.2 litre) dehumidifier. The Energy Star-compliant unit is designed to operate effectively in areas of up to 2,000 square feet. The electronic controls make it easy to set the two-speed fan while the low-temperature device enables it to operate until the temperature reaches 6.6C (44F). The model’s direct-drain system is perfect for continuous use while cleaning is as easy as pie due to the removable filter. This quiet appliance also comes with an automatic restart component and the built-in castors make it ideal for moving from room to room. The dehumidifier comes with a satisfying 24-month warranty on parts and labor.
|Product Width||33.97 cm||13 3/8"|
|Product Depth||25.24 cm||9.9375"|
|Product Height||54.45 cm||21 7/16"|
- 30 pint (14.2 L) dehumidifier covers approximately 2000 sq ft
- Energy Star compliant
- Electronic controls
- 2 speed fan
- Low temperature feature - continues to operate until temperature reaches 44F (6.6C)
- Auto Restart feature
- Removable filter for easy cleaning
- Quiet operation
- Castors for easy portability
- Direct drain system allows for continuous operation
ArcticAire 30 BTU Dehumidifier is rated out of 5 by 1.
Rated 2 out of 5 by Madhu from It stopped working after 3 years of service It worked good for last 3 years. Then, it stopped working. If I plug in within 30 sec, it shuts off. Kept it un-use for winters. Tried again, the same problem.
Date published: 2017-06-11
It is supposed to be there to help determine the water level.
We recommend setting your dehumidifier to between 40-50%.
This will vary based on humidity level. It will pump out the water when it reaches a certain level (pump models only).
There are a couple of reasons this could be occuring. 1) There may not be enough humidity in your environment or 2) Your relative humidity set higher than ambient humidity. Please adjust your settings accordingly if this is the case.
Yes, usually this air feels warm.
Information pertaining to watts and amps can be found on the rating plate located on the back of the unit.
This varies based on model. With some models you simply screw the hose onto the outlet on the back of the unit. With other models you have to remove the bucket, feed the hose through the back of the unit and connect to the adaptor above the bucket area, then replace the bucket. It is important to look at your control panel. Some units have a “continuous drain” button on the control panel. If that is the case for your unit, you must press this button after the hose is in place or the function will not work. Please refer to your owner’s manual.
This varies by model, however all dehumidifiers are a one shot timer. Please refer to the owner’s manual for timer instruction.
This is not recommended, as the unit is built to operate using the drain hose/power cord provided.
This varies based on model, however most models have been manufactured to have the fan turn off automatically.