Danby 60 Pint DehumidifierDDR060BECWDB
No one wants to sit in a humid home. You can find relief with this high-end dehumidifier by Danby. With a 60 pint (28.4 liters) capacity, this unit works best in areas up to 4,000 square feet. With its Energy Star® rating, paired with its R410a refrigerant, this unit is energy efficient and environmentally friendly. The electronic controls will allow you to change between two fan speeds. The auto-restart feature enables the unit to continuously operate until the temperature reaches 5ºC. The removable air filters make this unit easy-to-clean, and the castors make it easy to move from one room to another. To top things off, this attractive dehumidifier comes with a 24-month warranty on parts and labour.
|Product Width||40.96 cm||16 2/16"|
|Product Depth||30.00 cm||11 13/16"|
|Product Height||61.60 cm||24 4/16"|
- 60 U.S. pint (28.4 litre) capacity per 24 hours
- For areas up to 4,000 sq. ft. depending on conditions
- Energy Star® compliant
- Environmentally friendly R410A refrigerant
- Smart dehumidify function: Unit will automatically control room humidity by factoring in ambient temperature
- Electronic controls
- 2 Fan speeds (High/Low)
- Low temperature feature allows the system to continue to operate at temperatures as low as 5ºC (41ºF)
- Auto Restart: unit automatically restarts after a power failure
- Auto de-icer prevents frost build up
- Direct drain feature allows for continuous operation
- Reusable, washable air filter
- 4 castors for easy room to room transport
24 months parts and labour. Installation and/or yearly maintenance (cleaning) are not covered under warranty.
It is supposed to be there to help determine the water level.
We recommend setting your dehumidifier to between 40-50%.
Yes, usually this air feels warm.
There are a couple of reasons this could be occuring. 1) There may not be enough humidity in your environment or 2) Your relative humidity set higher than ambient humidity. Please adjust your settings accordingly if this is the case.
This will vary based on humidity level. It will pump out the water when it reaches a certain level (pump models only).
This varies based on model, however most models have been manufactured to have the fan turn off automatically.
This is not recommended, as the unit is built to operate using the drain hose/power cord provided.
This varies by model, however all dehumidifiers are a one shot timer. Please refer to the owner’s manual for timer instruction.
This varies based on model. With some models you simply screw the hose onto the outlet on the back of the unit. With other models you have to remove the bucket, feed the hose through the back of the unit and connect to the adaptor above the bucket area, then replace the bucket. It is important to look at your control panel. Some units have a “continuous drain” button on the control panel. If that is the case for your unit, you must press this button after the hose is in place or the function will not work. Please refer to your owner’s manual.