Skip to content

Danby Designer 50 BTU Dehumidifier

DDR503H This product is no longer available.
  • Danby
Danby Designer

Danby Designer 50 BTU Dehumidifier

DDR503H

Limited Quantity

  • Light Grey
Do the Right Thing.

Specifications

Dimensions
Product Width N/A
Product Depth N/A
Product Height N/A
Capacity
Loading Capacity
  • 50 BTU
  • 50 Pints
Package Dimensions
Package Width N/A
Package Depth N/A
Package Height N/A

Features

  • 50 U.S. pint (24 Liter) capacity per 24 hours 1200 watt heater For areas up to 2500 sq.ft. based on the conditions Automatic humidistat control starts/stops dehumidifier automatically Electronic controls Full bucket indicator light 2 fan speeds (high/low) Automatic de-icer Automatic shut-off Removable air filter is easy to clean Operating Level of 50 dB Large 12 pint (5.7 liter) Bucket Easy Roll Casters Direct Drain Option

FAQs

It is supposed to be there to help determine the water level.
We recommend setting your dehumidifier to between 40-50%.
Information pertaining to watts and amps can be found on the rating plate located on the back of the unit.
There are a couple of reasons this could be occuring. 1) There may not be enough humidity in your environment or 2) Your relative humidity set higher than ambient humidity. Please adjust your settings accordingly if this is the case.
This will vary based on humidity level. It will pump out the water when it reaches a certain level (pump models only).
This varies based on model, however most models have been manufactured to have the fan turn off automatically.
This is not recommended, as the unit is built to operate using the drain hose/power cord provided.
This varies by model, however all dehumidifiers are a one shot timer. Please refer to the owner’s manual for timer instruction.
This varies based on model. With some models you simply screw the hose onto the outlet on the back of the unit. With other models you have to remove the bucket, feed the hose through the back of the unit and connect to the adaptor above the bucket area, then replace the bucket. It is important to look at your control panel. Some units have a “continuous drain” button on the control panel. If that is the case for your unit, you must press this button after the hose is in place or the function will not work. Please refer to your owner’s manual.